Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″
Each of holders comes with a clamping Nut
Wrench and pull stud are not included

Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″
Each of holders comes with a clamping Nut
Wrench and pull stud are not included

Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″
Each of holders comes with a clamping Nut
Wrench and pull stud are not included

Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″
Gauge Length: 4.0″
Capacity of Collet:3/32– 1/2 (1-12mm)
Draw bar: M16x2.0
Each of holders comes with a clamping Nut
Wrench and pull stud are not included

Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″

Gauge Length: 2.76″

Capacity of Collet:1/8 – 3/4 (1-20mm)

Draw bar: M16x2.0

Each of holders comes with a clamping Nut
Wrench and pull stud are not included

Made of Special Alloy Steel
Surface hardened to 58-62 HRC
Dynamically balanced to G2.5 at 20,000RPM
Taper to taper runout <0.0002″

Gauge Length: 4.0″

Capacity of Collet:1/8 – 3/4 (1-20mm)

Draw bar: M16x2.0

Each of holders comes with a clamping Nut
Wrench and pull stud are not included